These Actuators are equipped with built-in Bourns potentiometers so you can determine the position of the actuator at any point in time via variable voltage feedback.

The potentiometer feedback runs on a 10K ohm 3-wire system, and the linear actuator is controlled by a two-wire system where reversing the polarity will retract the actuator; this system is easily wired to circuit boards for intelligent control, as well as relays, switches, and more. The Feedback Rod Actuator Line uses the MB1 Mounting Brackets and/or the MB6 Brackets

• For further information review the specifications and technical drawings
  • Equipped with built-in Bourns 10 turn Potentiometers with 10K Ohm resistance
  • Equipped with built-in limit switch
  • Available in 3 dynamic forces. 35lb, 150lb and 200lb
  • High-grade materials. An Aluminum inner and outer tube paired with zinc alloy housing for enhanced corrosion resistance resulting in long service life
  • Clevis mounting point on each end to ensure easy fitment
  • Compatible with the MB1 Mounting Brackets and/or the MB6 Brackets and with MB10 Rod End Bracket
  • Integrate with feedback reading device such as Arduino board to define preset positional limits.

Specifications