This is an actuator wiring kit that includes:

1. 12 foot roll of wire (red)
2. 12 foot roll of wire (black)
3. (2 ea) Micro switch with diodes soldered to back of each- Ideal if you want to stop an actuator in a different set position and stroke, lets say you want a 11" stroke rather than a 12" stroke, you can intall one of these micro switches into your system and the actuator will stop where you want it to. The diode is soldered across the back of the terminals so that you can still reverse direction once it reaches the limit switch
4. (10 ea) spade connectors (male and female)
5. 2 x fuse blocks with 10 amp fuse in each- Ideal for running 2 actuators together, if using only 1 actuator replace with a 5Amp fuse)

NOTE: This kit does not include control switches. Select your rocker or toggle switches in the accessories section.